Short FinalDOCS
Playing

Arrivals

From the edge of your airspace to the runway: STARs, holding, vectoring, the ILS, other approaches, speed control and Tower.

How an arrival reaches you

Arrivals appear at entry points on the edge of your airspace, usually between 9,000 and 13,000 ft, and call you: “Approach, Speedbird two seven alpha, with you at flight level one one zero, BIG one alpha arrival.” Each entry point feeds a holding fix (a filled triangle) and, unless you do something, the arrival flies to it.

With Handoffs set to Manual (Settings → Realism), centre offers you each arrival a couple of minutes before it reaches your airspace. Its strip shows Accept H/O. Accept it (A) before it crosses into your airspace, or it costs 50 points and is accepted for you. Until you accept, the pilot can't hear you.

STARs and the holding stack NEW IN 1.11

Every arrival is on a named arrival route (STAR) from its entry point to its holding fix, for example BIG 1A. It shows on the strip as STAR BIG 1A → OCK · FL80.

About 22 nm from the holding fix, an arrival you haven't given a level to descends on its own into the stack at that fix. Each one gets its own level: the lowest free level from FL70 (or just above the transition altitude) upwards, so two arrivals heading for the same stack are always at different levels. As soon as you give it an altitude, it follows yours instead.

Holding

An arrival that reaches its holding fix with no further clearance says “no further clearance, entering the hold” and circles there: inbound to the fix, a turn, then about 70 seconds outbound. That's Auto-hold (Settings → Gameplay); turn it off and arrivals just keep flying their last heading after the fix.

You can also hold any aircraft yourself: Hold here (H) holds over its present position, or type HOLD PELLA to hold at a fix. Holding is the safe answer when you're busy: nobody gets hurt in a hold.

Vectoring onto the ILS

The classic way to land a plane:

  1. Bring it down. Aim for 3,000–4,000 ft by the time it's about 10 nm from the runway. The glideslope is 3°, about 320 ft per nm, so at 10 nm it should be at about 3,200 ft.
  2. Point it at the centreline. Give it a heading that meets the dashed extended centreline at about 30°, several miles out from the runway. Too steep an angle and it overshoots the turn.
  3. Clear the ILS. Press I or Cleared ILS. The plane keeps its heading until it meets the centreline, then turns onto it by itself (“established runway two seven right”).
  4. Let it fly. Once established, it follows the centreline and the glideslope down, slows to its approach speed and lands. +100.

An aircraft counts as established when it's within about 1.3 nm of the centreline, between 0.5 and 32 nm out, and heading within 80° of the runway. Once established, you can't change its altitude (it's on the glideslope), but you can still turn it off the approach or send it round.

Tip

Leave a gap. Two aircraft on the same approach need 2.5 nm between them, so slow the one behind or lengthen its path before it joins.

Speed on the approach NEW IN 1.11

Established arrivals slow down in steps, like real ones: no faster than 220 kt beyond 12 nm, 180 kt from 12 to about 6.5 nm, then their own approach speed (115–150 kt depending on type).

Speed control on final

Give an established arrival a speed (S160 to S190, or the speed buttons) and it holds it until 4 miles, then slows to its approach speed: “maintain one six zero knots until four miles”. It's the real way to keep spacing on final. You can't do it inside 5 nm; it's too late to change speed by then.

Watch out

An arrival still more than 35 kt above its approach speed inside 1.5 nm goes around: “unstable approach, too fast”.

Hand it to Tower NEW IN 1.11

In real life, approach hands each arrival to the Tower controller once it's established. With Hand arrivals to Tower on (Settings → Realism, on by default), once an arrival is established press Contact Tower, the → Tower button on its strip, A, type TWR, or say “contact Tower”. The pilot reads back the frequency and leaves you.

  • An aircraft with Tower is off your frequency: you can't instruct it any more. Its strip shows TWR.
  • If it goes around, it comes back to you (“Approach, …, going around”).
  • Landing an arrival that's still on your frequency costs 20. Radio-failure aircraft are excused.

Visual and circling approaches

Visual approach

Choose Visual approach from Other approach… (or B, or VIS 27). The pilot flies a downwind, base and final to the runway on their own. It needs:

  • visibility of at least 5 km and cloud at 2,000 ft or higher, with no storm over the field;
  • the aircraft within 16 nm of the field and no higher than 7,000 ft.

Visual approaches are the only way onto a runway without an ILS.

Circling approach

Choose Circle to land from Other approach… (or CIR 09). The aircraft flies the ILS to a nearby runway, usually the other end of the same one, then breaks off and circles round to land on the runway you asked for. It needs cloud at 1,000 ft or higher and visibility of at least 2.5 km.

Go-arounds and missed approaches

An approach can end in a go-around. You can call one yourself (G), and pilots go around on their own when they must. Each go-around costs 25, unless it wasn't your fault (from 1.11).

ReasonWhyCosts points?
Too highStill well above the glideslope inside 2.5 nmYes
Runway occupiedSomething is still on the runway inside 2 nmYes
Runway closedThe runway closed with it inside 6 nmYes
Missed the runwayWasn't lined up at the thresholdYes
Unstable approach, too fast 1.11Far too fast inside 1.5 nmYes
WindshearFlew into a storm on finalYes
Windshear, gusty winds, unstable approach, birds, slow-vacating traffic 1.11Bad luck now and then, more often on windy daysNo

With Published missed approaches on (Settings → Realism), the aircraft flies the published procedure: straight ahead, then a turn to a holding fix, climbing to its missed-approach altitude, where it holds until you deal with it. Turn it off and go-arounds just climb straight ahead and wait for your instructions.

The QNH

With QNH on (Settings → Realism), the first time you descend an arrival below the transition altitude (usually 6,000 ft) or clear it for an approach, the QNH (pressure setting) is added to your instruction and the pilot reads it back. Listen: sometimes they read back the wrong number. Press QNH (Q) to send it again.

When arrivals go wrong

  • An arrival that flies out of your airspace costs 150.
  • Arrivals with emergencies have their own needs: see Emergencies.
  • Pilots ask for vectors round storms ahead of them: give them a heading. See Weather & wind.
Short Final documentation. Something wrong or missing? Tell us in the Discord.